LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 672 (Four-Wheel Drive Systems - Excursion & F250-F550 Super Duty) >> Removal And Installation >> Mode Indication Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Only vehicles with a mechanical shift transfer case are equipped with a mode indication switch.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
  2. Disconnect the wiring harness connector.
    Fig 1: Disconnecting Wiring Harness Connector
    G02776716Courtesy of FORD MOTOR CO.
  3. Remove the mode indication switch.
    Fig 2: Removing Mode Indication Switch
    G02776717Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals