LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 672 (Four-Wheel Drive Systems - Excursion & F250-F550 Super Duty) >> Removal And Installation >> Hublock >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hublock.
    1. Remove the retainer ring.
      2. CAUTION: To prevent damaging the hublock, do not use tools other than hands or "grip" gloves to remove the hublock.
      Fig 1: Removing Hublock
      G02776709Courtesy of FORD MOTOR CO.
    2. Pull outward and remove the hublock.
  2. To install, reverse the removal procedure.
    • Clean the O-ring seal contact area as necessary to provide a good O-ring seal. Install a new hublock O-ring seal kit. Apply a coat of grease to the O-ring seal and contact area.
    • Push the hublock in firmly by hand to seat the O-ring seal completely.
    • Be sure the retainer ring is completely expanded into the wheel hub groove.
scientia non olet · About LEMON Manuals