LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 669 (Clutch System - F250-F550 Super Duty) >> Removal And Installation >> Flywheel >> Removal

Removal And Installation: Flywheel: Removal

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the vehicle for flywheel removal.
    1. Remove the Transmission. Refer to MANUAL TRANSAXLE/TRANSMISSION - ZF 6 SPEED .
    2. Remove the clutch pressure plate and disc. Refer to CLUTCH DISC AND PRESSURE PLATE .
  2. Remove the flywheel.
    1. Remove the bolts. Install the guide studs.
    2. Remove the bolts.
    3. Remove the reinforcing ring (6.0L), and the flywheel and ring gear assembly.
    4. Remove the guide studs.
    Fig 1: Removing Flywheel (6.0L)
    G02776372Courtesy of FORD MOTOR CO.
    Fig 2: Removing Flywheel (5.4L & 6.8L)
    G02776373Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals