LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 666 (Automatic Transmission - 5R110W - Excursion & F250-F550 Super Duty) >> In-Vehicle Repair >> Transmission Insulator And Retainer >> Installation

Transmission Insulator And Retainer: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear transmission support insulator.
    1. Install the rear transmission support insulator.
    2. Lower the transmission onto the transmission support insulator.
      Fig 1: Installing Rear Transmission Support Insulator
      G02775764Courtesy of FORD MOTOR CO.
    2. NOTE: It may be necessary to raise the back of the transmission slightly in order to install the bolts.
    Fig 2: Installing Transmission Support Insulator Bolts
    G02775765Courtesy of FORD MOTOR CO.
  2. Loosely install the transmission support insulator bolts.
  3. Loosely install the transmission support insulator nuts.
    Fig 3: Installing Transmission Support Insulator Nuts
    G02775766Courtesy of FORD MOTOR CO.
  4. Tighten the transmission support insulator bolts and nuts.
    Fig 4: Tightening Transmission Support Insulator Bolts And Nuts
    G02775767Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals