LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 666 (Automatic Transmission - 5R110W - Excursion & F250-F550 Super Duty) >> In-Vehicle Repair >> Internal Harness Service >> Installation

Internal Harness Service: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push the bulkhead connector through the transmission solenoid body, twist it to lock it in place.
  2. Connect the internal wiring harness.
    1. Install the two screws.
    2. Connect the transmission fluid temperature sensor electrical connector.
    3. Connect the pressure switch electrical connectors (if equipped).
    4. Connect the solenoid electrical connectors.
      Fig 1: Connecting Internal Wiring Harness
      G02775680Courtesy of FORD MOTOR CO.
    3. NOTE: The O-ring must be installed in the top slot.
    Fig 2: Installing Solenoid Body Bulkhead Connector O-Ring
    G02775681Courtesy of FORD MOTOR CO.
  3. Install a new solenoid body bulkhead connector O-ring.
  4. Install the solenoid body.
scientia non olet · About LEMON Manuals