LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 665 (Automatic Transmission - 4R100 - Excursion & F250-F550 Super Duty) >> In-Vehicle Repair >> Transmission Insulator & Retainer >> Installation

Transmission Insulator & Retainer: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Be sure not to raise the back of the transmission too high. If it makes contact with the underbody, damage to the TSS and OSS sensors will occur.
  1. Install the rear transmission mount.
    1. Raise the transmission up.
    2. Install the rear transmission mount.
    3. Install the bolts.
      Fig 1: Installing Rear Transmission Mount
      G02775034Courtesy of FORD MOTOR CO.
  2. Lower the transmission on to the rear crossmember support.
    Fig 2: Lowering Transmission On-Rear Crossmember Support
    G02775035Courtesy of FORD MOTOR CO.
  3. Install the nuts.
    Fig 3: Installing Nuts
    G02775036Courtesy of FORD MOTOR CO.
  4. Remove the high-lift transmission jack.
  5. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals