LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 665 (Automatic Transmission - 4R100 - Excursion & F250-F550 Super Duty) >> In-Vehicle Repair >> Digital Transmission Range (Tr) Sensor >> Installation

Digital Transmission Range (Tr) Sensor: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the digital transmission range (TR) sensor.
    1. Install digital transmission range (TR) sensor.
    2. Loosely install the bolts.
      Fig 1: Installing Digital Transmission Range (TR) Sensor
      G02775021Courtesy of FORD MOTOR CO.
    NOTE: Make sure that the manual control lever is in the neutral position.
  2. Using the special tool, align the digital TR sensor. The tool is designed to fit snug.
    Fig 2: Aligning Digital TR Sensor
    G02775022Courtesy of FORD MOTOR CO.
  3. Tighten the bolts.
    Fig 3: Tightening Bolts
    G02775023Courtesy of FORD MOTOR CO.
  4. Reconnect the shift cable at the manual control lever.
    Fig 4: Connecting Shift Cable At Manual Control Lever
    G02775024Courtesy of FORD MOTOR CO.
  5. Reconnect the connector.
    Fig 5: Connecting Connector
    G02775025Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals