LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Electronic Engine Controls - Diesel Engine -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
  1. Turn the ignition switch to the OFF position.
  2. Disconnect the manifold absolute pressure (MAP) sensor.
    • Disconnect the pressure hose.
    • Disconnect the electrical connector.
    Fig 1: Disconnecting Manifold Absolute Pressure (MAP) Sensor
    G02773466Courtesy of FORD MOTOR CO.
  3. Remove the mounting screws and the MAP sensor.
    Fig 2: Removing Mounting Screws And MAP Sensor
    G02773467Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals