LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 663 (Electronic Engine Controls - Gasoline Engine -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Throttle Position (TP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. Refer to BATTERY, MOUNTING AND CABLES .
  2. Loosen the clamp and position the air cleaner outlet tube aside.
    Fig 1: Loosening Clamp
    G02773426Courtesy of FORD MOTOR CO.
  3. Remove the accelerator cable snow shield.
  4. Remove the throttle position (TP) sensor.
    1. Disconnect the electrical connector.
    2. Remove the screws.
    3. Remove the TP sensor.
    Fig 2: Removing Throttle Position (TP) Sensor
    G02773427Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals