LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 660 (Engine Emission Control System - Excursion & F250-F550 Super Duty) >> Removal And Installation >> Differential Pressure Feedback Exhaust Gas Recirculation (EGR) Sensor - 5.4L (2V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. Refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the differential pressure feedback EGR (if equipped).
    1. Disconnect the electrical connector.
    2. Disconnect the hoses.
    3. Remove the bolts (nuts if applicable).
      Fig 1: Disconnecting Electrical Connector & Vacuum Hoses
      G02773354Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals