LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 656 (Fuel System & Engine Controls - 5.4L (2V) - Excursion & F250-F350 Super Duty) >> Removal And Installation >> Throttle Body - Spacer >> Installation

Throttle Body - Spacer: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Follow the removal procedure in reverse order.
  2. Install the four throttle body spacer bolts.
    • Tighten to 8-10 Nm (71-88 lb-in).
    • Tighten an additional 85-95 degrees.
    Fig 1: Installing Throttle Body Spacer Bolts
    G02773050Courtesy of FORD MOTOR CO.
    Fig 2: Connecting EGR Tube
    G02773051Courtesy of FORD MOTOR CO.
    Fig 3: Positioning Cable Mounting Bracket Aside
    G02773052Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals