LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 654 (Engine - 6.8L - Excursion & F250-F550 Super Duty) >> Disassembly And Assembly Of Subassemblies >> Piston - Pin Connecting Rod, Floating Pin >> Assembly

Piston - Pin Connecting Rod, Floating Pin: Assembly

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Connecting rod must be installed into piston with identification markings toward front.
    Fig 1: Positioning Connecting Rod In Piston
    G02771652Courtesy of FORD MOTOR CO.
  1. Position the connecting rod in the piston.
  2. Lubricate the piston pin and pin bore with clean engine oil.
    Fig 2: Locating Lubricate Piston Pin And Pin Bore
    G02771653Courtesy of FORD MOTOR CO.
  3. Install the piston pin in the piston and connecting rod assembly.
    Fig 3: Installing Piston Pin In Piston And Connecting Rod
    G02771654Courtesy of FORD MOTOR CO.
  4. Install the piston pin retaining clips in the piston.
    Fig 4: Installing Piston Pin Retaining Clips In Piston
    G02771655Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals