LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (Engine System - General Information - Excursion & F250-F550 Super Duty (Gasoline)) >> General Procedures >> Crankshaft - Connecting Rod Journal Taper, Out of Round

Crankshaft - Connecting Rod Journal Taper, Out of Round

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the crankshaft connecting rod journal diameters in two directions perpendicular to one another at each end of the connecting rod journal. The difference in the measurements from one end to the other is the taper. Verify measurement is within the wear limit.
    • If out of specification, install new components as necessary.
      Fig 1: Measuring Crankshaft - Connecting Rod Journal Taper, Out Of Round
      G02770360Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals