LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 646 (Front Drive Axle/Differential -- Excursion & F250-F550 Super Duty) >> Specifications >> Torque Specifications

Torque Specifications

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Description Nm lb-ft
Pinion nut (1)(2)(3)(4) 217-678 160-500
Bolt retaining the front driveshaft to the front axle flange 35 26
Nut retaining the U-bolt to the axle 133 99
Nut and bolt retaining the trackbar to the axle 174 129
Bolt retaining the stabilizer bar bracket to the axle 47 35
Bolt retaining the differential bearing cap to the differential housing 109 80
Bolt retaining the differential housing cover to the differential housing 47 35
Bolt retaining the ring gear to the differential case 136 100
Fill plug 27 20
(1) Never back off the pinion nut to reduce preload. If preload reduction is necessary, install a new collapsible spacer and pinion nut.
(2) Take frequent pinion bearing torque preload readings.
(3) For new pinion bearing installation, tighten the pinion nut to a rotating torque of 1.7-3.4 Nm (15-30 lb-in)(217-678 Nm [160-500 lb-ft]).
(4) For original pinion bearing installation, the reading must be 0.56 Nm (5 lb-in) more than the initial reading taken during the disassembly procedure.
scientia non olet · About LEMON Manuals