Driveshaft - Front: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Install the front driveshaft with the index marks aligned.

NOTE: An extension must be used to tighten the driveshaft to transfer case bolts. Extensions change the calibration of the torque wrench. Use the torque wrench manual to calculate the correct settings.

NOTE: Install new bolts and retainers.

Fig 1: Removing Procedure (1 Of 3)

Courtesy of FORD MOTOR CO.

Fig 2: Removing Procedure (2 Of 3)

Courtesy of FORD MOTOR CO.

Fig 3: Removing Procedure (3 Of 3)

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.