LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 633 (Safety Belt System) >> Removal And Installation >> Safety Belt - Rear 3-Passenger Bench Seat >> Installation

Safety Belt - Rear 3-Passenger Bench Seat: Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure the safety belt webbing is not twisted prior to installation.
    NOTE: Make sure to tighten bolts to specification.
    Fig 1: Checking Active Restraint System For Correct Operation (1 Of 2)
    G02767518Courtesy of FORD MOTOR CO.
    Fig 2: Removing Active Restraint System For Correct Operation (2 Of 2)
    G02767519Courtesy of FORD MOTOR CO.
  1. To install, reverse the removal procedure.
    • Check the active restraint system for correct operation.