Removal and Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Remove the retaining nuts from the rear bumper (17906). Remove the rear bumper.
- Standard bumper shown.
Fig 1: Removing Retaining Nuts From Rear Bumper
Courtesy of FORD MOTOR CO.
Remove the retaining nuts from the rear bumper. Remove the rear bumper.
- Step-type bumper shown.
Fig 2: Removing Retaining Nuts From Rear Bumper
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Step-type bumper shown; standard bumper similar.
Fig 3: Installing Bumper
Courtesy of FORD MOTOR CO.