LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 599 (Automatic Transmission - 4R100) >> Disassembly & Assembly Of Subassemblies >> Center Support >> Disassembly

Center Support: Disassembly

WARNING: This page is about a different car, the 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove and discard the direct clutch seal rings.
    Fig 1: Removing And Discard Direct Clutch Seal Rings
    G02762345Courtesy of FORD MOTOR CO.
  2. Inspect the following for contamination or damage. Clean or install as necessary.
    1. Inspect the ball bearing.
    2. Inspect the feedbolt threads.
    3. Remove and inspect the No. 6 center support thrust washer.
    4. Inspect the inner hub diameter.
    5. Inspect the outer hub diameter.
    6. Inspect the seal ring grooves.
    Fig 2: Inspecting Following For Contamination Or Damage
    G02762346Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals