LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 597 (Electronic Engine Controls- Gasoline Engines) >> Removal And Installation >> Idle Air Control (IAC) Valve - 5.4L, 6.8L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Disconnect the idle air control (IAC) valve electrical connector.
    Fig 1: Disconnecting Idle Air Control (IAC) Valve Electrical Connector
    G02761798Courtesy of FORD MOTOR CO.
  4. Disconnect the throttle bypass hose.
    Fig 2: Disconnecting Throttle Bypass Hose
    G02761799Courtesy of FORD MOTOR CO.
  5. Remove the two bolts and the IAC valve.
    Fig 3: Removing Bolts And IAC Valve
    G02761800Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals