Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2004 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the aluminum retainer plate. These tools cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.

Clean and inspect the mating surface.

NOTE: Lubricate the inner lip of the crankshaft rear seal with clean engine oil.

Fig 1: Installing Crankshaft Rear Seal Using Special Tool

Courtesy of FORD MOTOR CO.

Use the special tools to install the crankshaft rear seal.
Using the special tools, install the crankshaft rear oil slinger.

Fig 2: Installing Crankshaft Rear Oil Slinger Using Special Tool
Courtesy of FORD MOTOR CO.
Install the flexplate. For additional information, refer to FLEXPLATE .