LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 580 (Rear Drive Axle/Differential-Ford 9.75" Ring Gear) >> In-Vehicle Repair >> Drive Pinion Seal >> Installation

Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new pinion seal with grease.
    2. CAUTION: If the pinion seal becomes misaligned during installation, remove the seal and install a new one.
    Fig 1: Installing Pinion Seal
    G02761081Courtesy of FORD MOTOR CO.
  2. Using the special tool, install the pinion seal.
  3. Install the pinion flange. For additional information, refer to DRIVE PINION FLANGE .
scientia non olet · About LEMON Manuals