Rear Safety Belt - Second Row, Quad Buckets

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Special Tool(s)

Courtesy of FORD MOTOR CO.

MATERIAL SPECIFICATION

Item	Specification
Clear Silicone Rubber D6AZ-19562-AA	ESB-M4G92-A

WARNING: All safety belt assemblies including retractors, buckles, shoulder belt height adjusters (if so equipped) child safety seat tether attachments and attaching hardware should be inspected after any collision. All belt assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.

NOTE: RH side shown, LH side similar.

To access the shoulder height adjuster, position aside the C -pillar upper trim panel. For additional information, refer to INTERIOR TRIM PANELS .
To access the second row safety belt buckle, tilt the second row seat forward.
To access the second row safety belt retractor, remove the rear quarter trim panel. For additional information, refer to INTERIOR TRIM PANELS .

Remove the parts in the order listed in the following illustration and table.

To remove individual parts, only carry out the listed steps:

PART REMOVAL STEPS

Part	Steps
Safety Belt Shoulder Height Adjuster (Second Row)	3, 6-7
Safety Belt Retractor (Second Row)	3-5
Safety Belt Buckle (Second Row)	1, 2

Fig 2: Removing Rear Safety Belt - Second Row, Quad Buckets Components

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.