LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 560 (HVAC - Climate Control System) >> Removal And Installation >> Temperature Blend Door Actuator - Auxiliary

Temperature Blend Door Actuator - Auxiliary

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the vehicle on a hoist with the gear selector in NEUTRAL. For additional information, refer to JACKING & LIFTING .
  2. Remove the LH quarter trim panel. For additional information, refer to BODY SYSTEM - INTERIOR .
  3. Remove the parts in the order indicated in the following illustration and table.
    Fig 1: Identifying Removal Sequence Of Temperature Blend Door Actuator - Auxiliary
    G03182978Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals