LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 558 (Fuel System) >> Removal And Installation >> Fuel Tank and Filler Pipe - 4.0L SOHC Early Build >> Item 11: Fuel Supply Line Removal Note

Item 11: Fuel Supply Line Removal Note

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel filter shield.
    1. Remove the two nuts.
    2. Remove the shield.
    Fig 1: Removing Fuel Filter Shield
    G03182516Courtesy of FORD MOTOR CO.
  2. Disconnect the safety clip.
    Fig 2: Disconnecting Safety Clip
    G03182517Courtesy of FORD MOTOR CO.
  3. Install the special tool and push it into the fitting.
    Fig 3: Installing Special Tool And Push It Into Fitting
    G03182518Courtesy of FORD MOTOR CO.
  4. Separate the fitting.
    • Inspect the damage.
    • Clean the fittings.
    Fig 4: Inspecting Damage Part
    G03182519Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals