Item 12: Solenoid Body Harness Connector Installation Note
WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Install and lubricate new O-ring seals on the transmission connector and connect the connector.
CAUTION:
Damage will occur to the solenoid body assembly if the screw is tightened above the specification.
NOTE:
Always install new O-ring seals on the vehicle harness connector.
NOTE:
Clean the area around the connector to prevent contamination of the solenoid body connector.
NOTE:
Use petroleum jelly to lubricate the O-ring seals to aid in the installation process.