DRIVE MODE Procedure for GEAR

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Follow operating instructions from the NGS menu screen.

Select "Output State Control."
Select "Trans - DRIVE MODE."
Select "PIDs" to be monitored.
Monitor all selected PIDs during test.
Select "Parameters - GEAR."
Select Value "1-5."
Press "SEND" to send command.
Reselect Value "1-5."
Press "SEND" to send command.
Select "XXX" to cancel at any time.
Press "SEND."