BENCH MODE Procedure for SSA, SSB, SSC, SSD and TCC

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Follow operating instructions from the NGS menu screen:

Select "Output State Control."
Select "Trans - Bench Mode."
Select "PIDs" to be monitored.
Monitor all selected PIDs during test.
Select "Parameters - SSA, SSB, SSC, SSD or TCC."
Select "ON" to turn solenoid ON.
Press "SEND" to send command ON.
Select "OFF" to turn solenoid OFF.
Press "SEND" to send command OFF.
Select "XXX" to cancel at any time.
Press "SEND."