LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 555 (Intake Air System, Fuel Charging System & Engine Electronics System-4.6L (2V) Engine) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Notes

Crankshaft Position (CKP) Sensor: Notes

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in neutral, position it on a hoist. For additional information, refer to JACKING & LIFTING
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY DISCONNECT
  3. Remove the drive belt from the a/c compressor pulley. For additional information, refer to ENGINE - 4.6L (2V) .
  4. Remove the parts in the order indicated in the following illustration and table.
    Fig 1: Identifying Crankshaft Position (CKP) Sensor Components
    G03181891Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals