LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 555 (Intake Air System, Fuel Charging System & Engine Electronics System-4.6L (2V) Engine) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Item 3: Power Steering Pump Bolt Installation Note

Item 3: Power Steering Pump Bolt Installation Note

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tool, install a new O-ring seal on the power steering high pressure tube.
    Fig 1: Installing O-Ring Seal On Power Steering High Pressure Tube
    G03181886Courtesy of FORD MOTOR CO.
  2. Connect the high pressure power steering tube.
    Fig 2: Connecting High Pressure Power Steering Tube
    G03181887Courtesy of FORD MOTOR CO.
  3. Install the support bracket.
    Fig 3: Installing Support Bracket
    G03181888Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals