LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 552 (Engine - 4.6L) >> In-Vehicle Repair >> Camshaft, Valve Springs and Valve Seals >> Items 7-5: Camshaft Sprocket Installation Note

Items 7-5: Camshaft Sprocket Installation Note

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the camshaft gear spacer.
  2. Install the camshaft sprocket. Tighten the sprocket bolt in two stages.
    • Stage 1: Stage 1: Tighten to 40 Nm (30 lb-ft).
    • Stage 2: Tighten an additional 90 degrees.
    Fig 1: Installing Camshaft Gear Spacer
    G03181154Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals