LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Body Panel System - Exterior) >> Removal And Installation >> Front Bumper >> Item 9: Bumper Beam Removal Note

Item 9: Bumper Beam Removal Note

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Right side shown, left side similar.
    Fig 1: Drilling Out Four Spot Welds
    G03246709Courtesy of FORD MOTOR CO.
  1. Drill out the four spot welds.
  2. Disconnect the ambient air temperature wire harness from the lower bumper.
    Fig 2: Disconnecting Ambient Air Temperature Wire Harness
    G03246710Courtesy of FORD MOTOR CO.