LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 525 (Intake Air, Fuel Charging, & Engine Electronics) >> Removal And Installation >> Starter Motor

Starter Motor

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: When carrying out maintenance on the starting system be aware that the heavy gauge leads are connected directly to the battery. Make sure the protective caps are in place when maintenance is completed.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to IDENTIFICATION CODES .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY & CHARGING SYSTEM
  3. Remove the parts in the order indicated in Fig 1.
    Fig 1: Starter Motor Parts Removal Sequence
    G03244335Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals