LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 523 (Engine) >> In-Vehicle Repair >> Crankshaft Pulley and Crankshaft Seal >> Item 3: Subframe Bolt Removal Note

Item 3: Subframe Bolt Removal Note

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the RH front anti -lock brake wheel sensor electrical connector.
    Fig 1: Disconnecting RH Front Anti-Lock Brake Wheel Sensor Electrical Connector
    G03243839Courtesy of FORD MOTOR CO.
  2. Position a safety stand under the RH side of the subframe.
    Fig 2: Positioning Safety Stand Under RH Side Of Subframe
    G03243840Courtesy of FORD MOTOR CO.
  3. Lower the RH side of the subframe 50.8 mm (2 in).
    • Remove the bolts.
    • Lower the subframe.
      • Fig 3: Lowering RH Side Of Subframe
      G03243841Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals