Item 3: Brake Pads Installation Note
WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
- One brake disc pad kit contains the pads required for both sides.
- If replacing the brake pads, use a suitable suction device to remove the brake fluid from the master cylinder reservoir until it is half filled.
- If replacing the brake pads, use the special tool to retract the brake caliper piston into the caliper bore.
CAUTION:
Only install new brake pads if the lining is not within specifications. Install new pads in complete axle sets.
CAUTION:
Make sure the slot in the caliper piston lines up with the locating pin on the brake pad. Failure to line up the locating pin with the slot will cause uneven brake pad wear.