Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.

Raise and support the hood.
Remove the screws and the sight shield.

Fig 1: Removing Sight Shield
Courtesy of FORD MOTOR CO.
Pull up on the two retainer pins.

Fig 2: Pulling Up On Two Retainer Pins
Courtesy of FORD MOTOR CO.
Pull the headlamp assembly forward.

Fig 3: Pulling Headlamp Assembly Forward
Courtesy of FORD MOTOR CO.
Disconnect the two electrical connectors.

Fig 4: Disconnecting Two Electrical Connectors
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- If necessary, adjust the headlamps. For additional information, refer to HEADLAMP ADJUSTMENT .