LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 473 (Electronic Engine Control System) >> Removal And Installation >> Idle Air Control (IAC) Valve - 3.0L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the idle air control (IAC) valve electrical connector.
    Fig 1: Disconnecting IAC Valve Electrical Connector
    G03275343Courtesy of FORD MOTOR CO.
  3. Remove the IAC valve and discard the gasket.
    Fig 2: Removing IAC Valve And Discarding Gasket
    G03275344Courtesy of FORD MOTOR CO.
    4. NOTE: Install a new IAC valve gasket.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals