Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

LEFT SIDE SENSOR

Raise and support the vehicle. For additional information, refer to JACKING & LIFTING .

RIGHT SIDE SENSOR

Remove the right front wheel and tire assembly. For additional information, refer to WHEELS & TIRES .
Position aside the right front fender splash shield.

Fig 1: Positioning Right Front Fender Splash Shield Aside
Courtesy of FORD MOTOR CO.

BOTH SENSORS

NOTE: If necessary, lubricate the HO2S with lock lubricant to assist in removal.

Fig 2: Removing HO2S

Courtesy of FORD MOTOR CO.

Using the special tool, remove the HO2S.

NOTE: Apply a light coat of anti -seize lubricant to the threads of the HO2S.

To install, reverse the removal procedure.