LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 463 (Engine - 4.0L SOHC) >> In-Vehicle Repair >> Timing Drive Components - Hydraulic Chain Tensioner, RH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS & TIRES .
  2. Remove the lower splash shield.
    Fig 1: Removing Lower Splash Shield
    G03274460Courtesy of FORD MOTOR CO.
  3. Remove the RH camshaft tensioner.
    Fig 2: Removing RH Camshaft Tensioner
    G03274461Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals