LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 463 (Engine - 4.0L SOHC) >> In-Vehicle Repair >> Hydraulic Lash Adjusters >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft roller followers. For additional information, refer to ROLLER FOLLOWERS .
  2. Remove the hydraulic lash adjusters.
    Fig 1: Removing Hydraulic Lash Adjusters
    G03274488Courtesy of FORD MOTOR CO.
    3. NOTE: Lubricate the parts with clean engine oil prior to installing.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals