LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 462 (Engine - 3.0L (2V)) >> In-Vehicle Repair >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  3. Remove the fan blade and the fan shroud. For additional information, refer to ENGINE COOLING .
  4. Remove the accessory drive belt. For additional information, refer to SPECIFICATIONS & DRIVE BELT ROUTING .
  5. Remove the crankshaft pulley.
    Fig 1: Removing Crankshaft Pulley
    G03274020Courtesy of FORD MOTOR CO.
  6. Remove the bolt and the washer.
    Fig 2: Removing Bolt And Washer
    G03274021Courtesy of FORD MOTOR CO.
  7. Using a Crankshaft Vibration Damper Remover, remove the crankshaft damper.
    Fig 3: Removing Crankshaft Damper
    G03274022Courtesy of FORD MOTOR CO.
  8. Remove the crankshaft key, if necessary.
    Fig 4: Removing Crankshaft Key
    G03274023Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals