LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 461 (Engine - 2.3L) >> In-Vehicle Repair >> Crankshaft Rear Seal with Retainer Plate >> Installation

Crankshaft Rear Seal with Retainer Plate: Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the crankshaft rear oil seal on the Crankshaft Rear Main Oil Seal Installer.
  2. Install the Crankshaft Rear Main Oil Seal Installer and the crankshaft rear oil seal on the crankshaft.
    • Tighten the bolts in the sequence shown to 10 N.m (89 lb -in).
      Fig 1: Crankshaft Rear Main Oil Seal Bolts Tightening Sequence
      G03273706Courtesy of FORD MOTOR CO.
  3. Remove the Crankshaft Rear Main Oil Seal Installer.
  4. Install the oil pan. For additional information, refer to OIL PAN .
  5. Install the flywheel or flexplate. For additional information, refer to FLYWHEEL  or FLEXPLATE .
scientia non olet · About LEMON Manuals