LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 453 (Front Drive Axle/Differential - DANA 35) >> Removal And Installation >> Bushing >> Installation

Removal And Installation: Bushing: Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Axle tube bushing installation shown, axle housing bushing is a similar procedure.
  1. Position the tube bushing and the tube bushing installation tools.
    1. Position the tube bushing.
    2. Position the Ring Gauge.
    3. Position the Bushing Collet Replacer.
    4. Position the Bushing Cup Remover/Replacer.
    5. Position the Drawbolt.
    6. Thread the Bushing Replacer on the Drawbolt.
      Fig 1: Positioning Tube Bushing And Tube Bushing Installation Tools
      G03272995Courtesy of FORD MOTOR CO.
  2. Tighten the Drawbolt to install the tube bushing.
    • Remove the tools.
      Fig 2: Installing Tube Bushing
      G03272996Courtesy of FORD MOTOR CO.
  3. Install the front axle assembly. For additional information, refer to AXLE ASSEMBLY - FRONT .
  4. Check the fluid level and fill the axle to specification with lubricant.
  5. Lower the vehicle.
  6. If equipped with air suspension, reactivate the system by turning on the air suspension switch.
scientia non olet · About LEMON Manuals