General Specifications Chart
WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS CHART
| Item | Specification |
|---|---|
| Lubricants and Sealants | |
| SAE 75W-140 Synthetic Rear Axle Lubricant XY-75W140-QL |
WSL-M2C192-A |
| Additive Friction Modifier XL-3 |
EST-M2C118-A |
| Premium Long-Life Grease XG-1-C |
ESA-M1C75-B |
| Silicone Rubber F7TZ-19554-AA |
WSS-M4G320-A3 |
| Threadlock and Sealer EOAZ-19554-AA | WSK-M2G351-A5 |
| Backlash Specifications | |
| Backlash between ring gear and pinion teeth | 0.254-0.304 mm (0.010-0.012 in) |
| Ring gear maximum backlash variation between teeth | 0.050 mm (0.002 in) |
| Rotational Torque Ranges | |
| Pinion bearing preload (used pinion bearings) | 0.9-1.5 N.m (8-14 lb-in) |
| Pinion bearing preload (new pinion bearings) | 1.8-3.3 N.m (16-29 lb-in) |
| Adapter for 205-S127 | 2.2 N.m (20 lb-in) |
| Initial minimum breakaway torque | 27 N.m (20 lb-ft) |
| Clearance Specifications | |
| Differential case maximum runout | 0.076 (0.003) |
| Maximum axle shaft end play | 0.762 (0.030) |
| Pinion flange maximum runout | 0.25 (0.010 T.I.R.) |
| RABS sensor air gap | 0.127-1.143 (0.005-0.045) |