LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Exterior Trim) >> Removal And Installation >> Cowl Panel Grille

Cowl Panel Grille

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. To remove individual components, only carry out the listed steps.
    COMPONENTS REMOVING STEPS

    Component Steps
    LH pivot arm 1-3
    RH pivot arm 4-6
    Cowl vent screen assembly 1-7,9-10
  2. Remove the components in the order listed in the following illustration and table.
    Fig 1: Removing Cowl Panel Grille Components
    G03203568Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.

Item 9: Washer Hose Removal Note 

  1. Disconnect the washer hose for cowl vent panel removal.

Item 3: Windshield Wiper Pivot Arm Installation Note 

  1. Cycle and park the windshield wipers.
  2. Install the windshield wiper pivot arm onto the pivot shaft and align the blade to the silver dots in the windshield.

Item 6: Windshield Wiper Pivot Arm Installation Note 

  1. Cycle and park the windshield wipers.
  2. Install the wiper blade and pivot arm onto the pivot shaft and align the blade to the silver dots in the windshield.