LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 424 (Intake Air, Fuel Charging, Starting & Engine Electronics - 3.0L) >> Removal And Installation >> Fuel Pressure Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable.
  2. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM .
  3. Remove the cowl vent screen. For additional information, refer to EXTERIOR TRIM .
  4. Remove the components in the order indicated in the following illustration and table. See Fig 1.
  5. To install, reverse the removal procedure.
    Fig 1: Removing Fuel Pressure Sensor
    G03201498Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals