LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 424 (Intake Air, Fuel Charging, Starting & Engine Electronics - 3.0L) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor

Cylinder Head Temperature (CHT) Sensor

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable.
  2. Remove the components in the order indicated in the following illustration and table. See Fig 1.
  3. To install, reverse the removal procedure.
    Fig 1: Removing Cylinder Head Temperature (CHT) Sensor
    G03201497Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals