LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 423 (Engine Cooling) >> Removal And Installation >> Water Pump - 3.0L (4V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this section.
  2. Remove the electric cooling fan. For additional information, refer to RADIATOR, COOLING FAN AND SHROUD  in this section.
  3. Remove the accessory drive belt. For additional information, refer to ENGINE - 3.0L (4V) .
  4. Remove the components in the order indicated in the following illustration and table.
  5. To install, reverse the removal procedure.
    Fig 1: Water Pump - 3.0L (4V) Components Removal Sequence
    G03201433Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals