Removal and Installation

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in neutral, position it on a hoist.
Remove the intake manifold tuning valves. For additional information, refer to INTAKE AIR, FUEL CHARGING, STARTING & ENGINE ELECTRONICS - 3.0L (4V) .
Remove the fresh air inlet duct housing. For additional information, refer to CLIMATE CONTROL SYSTEM . .
Remove the components in the order indicated in the following illustration and table.
To install, reverse the removal procedure.

Fig 1: Removing Engine Mount - LH
Courtesy of FORD MOTOR CO.

Item 2: Intermediate Shaft Pinch Bolt Removal Note

CAUTION: The steering wheel must be in the locked position, or the lower end of the column wired in such a way that the steering column does not rotate, resulting in damage to air bag sliding contact.

Disconnect the steering coupling.

Item 9: Center Crossmember Bolts Removal Note

Loosen the center crossmember bolts.

Item 10: LH Engine Mount Removal Note

Raise the engine and lower the center crossmember to remove the LH engine mount.