Removal & Installation

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING & BLEEDING - 2.3L .
Disconnect the electrical connector.

Fig 1: Disconnecting Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the engine coolant temperature sender unit.

Fig 2: Removing Engine Coolant Temperature Sender Unit
Courtesy of FORD MOTOR CO.

NOTE: Coat the threads with pipe thread sealant.

To install, reverse the removal procedure.