LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 391 (Engine System -- General Information - Ranger) >> General Procedures >> Valve - Stem Diameter

Valve - Stem Diameter

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the diameter of each intake and exhaust valve stem at the points shown. Verify the diameter is within specification.
    • Refer to appropriate ENGINE article for the procedure.
    • If out of specification, install new components as necessary. Refer to appropriate ENGINE article for the procedure.
    Fig 1: Measuring Valve Stem Diameter
    G03435326Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals